One of the most prevalent CV joint issues is when the protective boot breaks or cracks, resulting in CV joint failure. Debris and dampness will enter the CV joint as grease leaks. Due to a lack of lubrication and corrosion, the CV joint will wear out faster and fail.
When turning, the click, click sound is one of the most prevalent indications of a damaged CV joint. Under excessive acceleration, a similar sound will be heard.
As soon as you hear this sound, search for car services in Reading online and book your car with a professional car mechanic to diagnose the CV joint and carry out any necessary repairs or replace parts.
Sound Of a Bad CV Joint
Outer CV joint boots are more likely to be destroyed than inner boots because they must resist more movement. They're closer to the steering wheel, which has to move up and down when you hit bumps or potholes. The condition of the CV joint boot should be checked on a regular basis.
If you find a crack in the CV joint boot, it should be replaced or repaired right away by booking your car in with a car garage in Reading. The technician will inspect the vehicle for any tears, cracks, or other damage and advise on the best course of action.
Front-wheel drive, rear-wheel drive, and all-wheel-drive cars all use CV joints, also known as constant-velocity joints. When they fail, you'll notice a clicking sound when turning, especially if you're speeding.
Signs Of a Bad CV Joint
When turning or accelerating, the most common CV joint symptom is a clicking noise. The following are 6 common signs of a faulty CV joint:
1. When turning, there is a click, click noise.
2. The rubber or plastic boot that covers the CV joint has cracks or splits.
3. Grease dripping over the wheel rim or into the wheel well due to cracks.
4. When travelling around slow corners, hearing a clicking sound from the wheels. This indicates damage to the outer CV joints.
5. When the car is moving straight, you might hear sounds. This could possibly be damage to the inner CV joints.
6. During acceleration, the car shudders or shakes.
CV Joint Failure Prevention
Check for grease leaks at the CV joint, especially on the external CV boot. Also, make sure the CV joint clamps aren't cracked or loose.
Visually examine your CV joints for wear, ripping, cracks, or other damage to the boot on a regular basis. Early detection of possible faults can save money on repairs and prevent more significant damage to the vehicle's driveshaft, wheels, or entire CV joint.
CV Joint Replacement
Damage to a CV boot may be detected early, which allows the boot to be changed and the joint to be resealed with new grease. Replacements are usually offered as a kit that includes a new CV boot, lubricant, and clamps that are particular to the vehicle. It is less costly than replacing the complete CV joint or the driveshaft.
If the damage is more extensive than a cracked boot and the CV joint is too worn to function, it will need to be replaced. CV joints are not repairable and must be replaced with a new part. Furthermore, because the CV joint is not offered separately, you may not be able to repair it alone and have to replace the entire CV joint or driveshaft.
Depending on your vehicle, the instructions for changing the CV boots, joints, or driveshaft will differ. Replacing the CV joint is a difficult task that will become much more costly if special tools are required to perform the job. That cost, along with the time invested may be compared to the cost of having the job done at a garage in Reading by a trained car mechanic.
Is it possible for me to fix a CV joint on my own?
You can change the driveshaft or CV joint boot on your own, but to undo the hub nut or CV joint locknut, you'll need the correct size socket and a breaker bar or torque wrench.
The lower ball joint will also need to be removed, which is difficult to perform without the proper equipment. You must re-torque the hub nut to the recommended torque after replacing the CV joint boot.
Comments